Hold 1 Of The Rj 45 Connectors example essay topic

318 words
How to make a network patch cable A net work patch cable is used to connect a computer or any other device that connects to a local area network to the hub or a wall jack. The most commonly used patch cable is Category 5, there is also Category 5 e, and Category 6. Category 6 is the fastest for transferring data, but it is also the most expensive. This set of instructions will show how to make a category 5 patch cord.

Get the following supplies and tools around first: 10 feet of UTP (Unshielded twisted Pair) Category 5 wire 2 - RJ-45 connectors 1 - RJ-45 crimp connector 1 - Category 5 Cable Stripper 1. Strip 3/4 of an inch off of one end of the category 5 cable 2. Separate the colored pairs into 4 groups the orange with the orange-white, the blue with the blue-white, the green with the green-white, and the brown with the white 3. Now flatten the wires out 4. From left to right sort the wires so that it is orange-white, orange, green-white, blue, blue white, green, brown white, brown. (Use the diagram on the Right to help) 5.

Now hold 1 of the RJ-45 connectors so that the contacts are on top and that the tab is on the bottom. 6. Push the wires in the connector making sure that the wires stay in the same position. 7.

Make sure to push the tips of the wires to the front of the connector. 8. Put the connector in the crimper make sure that the wires keep touching the front of the connector. 9. Squeeze the handles on the crimper together, and than release the handle. 10.

Now repeat Steps 1 through 9 for the other end of the wire.