Solubility Lab And The Density Labs example essay topic

Error Analysis In such a big lab, so many errors can occur and even one little one can ruin everything. One could have missed a procedure or done a procedure incorrectly. Another could have been using the incorrect amount of liquid or sludge. Someone could have lost a test-tube or labeled it wrong causing the results to be mixed. Using too much water in the solubility tests or not getting all measurements almost exactly accurate could be two sources of error. One big mistake could be creating a vacuum in the fractional Distillation part of the lab.

One careless mistake could have been doing the calculations incorrectly. Conclusion The sludge lab is a long and complicated lab. So much can go wrong so easily. So we had to be very careful when doing this lab. It was basically a recap of all our previous labs done this year. First we used the Fractional Distillation.

Then we used the Solubility lab and the density labs. Only new part was identifying the metal, but that wasn't very hard. So it was good that we reviewed our lab reports. This way we knew what procedures to take and what mistakes not to make. So it seems like we did everything right because the results make sense. To get and identify Fraction I, we had to do a lot.

First we filtered the sludge. Then we took 25 cm 3 of the sludge and separated it into three parts. So we took the first fraction and experimented on it. We purified it and determined its boiling point, density and solubility.

We also had to see if it had an odor and whether it was flammable or not. After doing all this we realized that this Fraction was Isopropanol Alcohol. We came to this conclusion by looking at our data for the solubility, density, odor, boiling point, and flammability. To get and identify Fraction, we had to continue from Fraction I. After getting the first fraction we had to change tubes and et 2 more fractions. We threw away the 2nd because it was just a leftover mix. We took the third fraction and experimented on it.

After doing all this we realized that this Fraction was Water. Determining the soluble solid was hard and a rigorous procedure. After boiling away 25 cm 3 of liquid, the boiling chips and a salt were left. We took the chips out and put a little bit of water and mixed it with the salt. Now we had a saturated solution.

Then we followed the procedures for solubility and calculated everything. After doing so we had to see the salts solubility in alcohol and water and check its shape. We also had to conduct a flame test. After closely examining the data and checking the facts. We cam to the conclusion that this slat was Sodium Nitrate. Determining the Insoluble solid was an easy and simple procedure.

Once we filtered out the sludge, we saw that there was a metal in it... So we took the metal out and checked it was magnetic. We saw that it was a marble shaped, silvery whitish metal. Also had to observe what it changed the flame color to. You can not figure out what an object without finding its density, and so we did that. After all these tests we realized the metal was iron.