To Make Tobacco Bongs A Tobacco Bong example essay topic

626 words
How To Make Tobacco Bongs A tobacco bong is another way for someone to smoke tobacco instead of just rolling a cigarette you can just stuff the tobacco in a bowl and smoke it. It is much quicker and easier to do than rolling it in papers. There are many types of tobacco bongs but I'm only going to explain how to make two different types because I dont have enough time to explain how to make all of them. That would take forever. The first type im going to explain how to make is a gravity bong. The other type is a water bong.

A gravity bong is probably one of the easiest and cheapest ones to make. All you have to have is a 2-liter bottle, 5 gallon bucket filled with water, aluminum foil, a sharp knife, tobacco, and a lighter. The first thing you do is take the lid off of the 2-liter bottle and then cut the bottom off with the sharp knife. Then put the aluminum foil over the top of it and push it down inside of it a little to make a little bowl for the tobacco. Poke about six or seven little holes in the aluminum foil. And that is how you make the gravity bong.

To use it all you have to do is put the 2-liter bottle in the water and push it all the way down, but dont push it to far down just push it to where the water is almost up to the aluminum foil and then put the tobacco in it and hold the lighter close to the tobacco and pull up on the bottle. The suction pulls the smoke inside the bottle and when you get the bottle almost out of the water, pull the aluminum foil off and put your mouth over the hole and push the bottle back into the water. The pushes the smoke down your throat. A honey bear bong is pretty easy to make also. All you have to have is an empty honey bear bottle, a bowl, which costs about a dollar at any smoke shop, 1 foot of 3/4 inch rubber hose, tobacco and a lighter. First you need to be sure most of the honey is out of the bottle but leave about a half inch of it in the bottom.

Then you get the sharp knife and cut a hole, about two and a half inches from the bottom, in it big enough for the 3/4 inch hose to stick through and when you do that put the hose in the hole and if it isn't air tight you can put some silicone or chewing gum around it. Then where the hole is for the honey to come out of, just get the knife and carve it out big enough for the bowl to sit in. If you want to you can cut a small hole behind one of the bear's ears and use that as a care. Then just pack it with tobacco and light it while sucking through the hose and be sure you have the care plugged and when the smoke gets real thick inside let go of the care and suck it down. In no way am I promoting any kind of drugs. Smoking tobacco or any other drugs through this may cause cancer.

I do not recommend that you smoke during pregnancy, if you have a bad heart, or if you are ill in any way. Long term smokers may eventually die from smoking. So do not try this at home..